When playing flute, you can use fluctuating sound naturally, a bit like human voice, and the sound is very beautiful. The flute has a wide range and is very dexterous. It can not only play lyrical and slow melody, but also can play fast, bounce up and down sound patterns, as well as colorful melodies such as decorative sounds and voicing sounds without difficulty. So it has always been valued in orchestras, military bands, ensemble bands and light music teams.
The flute in the traditional appellation refers to a group of musical instruments, which is composed of C-tune piccolo, C-tune flute, G-tune midrange flute and C-tune bass flute. In orchestras and military bands, the C flute and C piccolo are the most used.
[Flute making process]
The structure of the instrument The flute can be divided into three parts: head, body and tail.
The mouthpiece is the first section of the instrument, with a blow hole on it, which is used to produce sound. The top of the mouthpiece is a flute cap, and the flute cap has a screw connected to the cork inside the mouthpiece. Rotate the flute cap to adjust the position of the cork in the flute head. Please note that the position of the cork inside the mouthpiece has been adjusted when the instrument leaves the factory. If there is no special situation, students should not turn the mouthpiece at will.
The flute body is the second segment, and the flute tail is the third segment, with sound holes and linkage buttons on it. Opening or closing the sound hole will change the height of the pronunciation.
The flute sound hole
1, the pull-up tube wall is pulled out from the material of the flute body, which can make the flute sound range wider and brighter
2, the brazed sound hole tube wall is welded to the flute body, the sound is more concentrated and thick
3, Welded and undercut type Welded sound holes with undercut inner edges make the sound louder and full of vitality.
taper Y taper: Standard 2-level taper, excellent midrange and treble performance, warmer sound quality, easier to control
C taper: French taper, direct, free, gorgeous sound quality
G taper: German taper , The tone is rich, the midrange is solid, and has a strong sense of resistance. Square shape, rich timbre, good resistance to resistance
C mouthpiece: large cut, smooth and free pronunciation, solid bass, rich expressiveness
E mouthpiece: high blow hole wall, the cut is smaller than the C-cut, and the sound is full, It is very comfortable to play.
H mouthpiece: similar to the C-cut, but the side cut is smaller to increase the sense of resistance. The tube head is French cone type, the front of the lip pad is bent into an acute angle, the sound is stable and favorable, and the sound projection is even.
BC--The lip pad is bent into an acute angle, the mouthpiece is slightly rounded, the tone is full and warm, and the sound is very harmonious when played.
CC--More Wide cutting area, smooth air circulation, concentrated timbre, good bass resonance, and full range of sound is very consistent.
EC--high narrow tube wall, excellent resonance and ideal tone control air resistance, blowing response is brisk and direct
HC--small The cutting area is matched with the French cone type, which provides high-quality sound with greater plasticity, but slightly stronger resistance.
SC--Very unique, very subtle feeling, and excellent resonance.
CG--German cone type sound is very concentrated, The sound is more concentrated and the playing resistance is stronger.
CY--similar to the French cone type but divided into two-stage cone, the tone is gentle and deep, and the sound is concentrated in the middle and high range. The taper of
is as follows:
4z
4z
4z
z0 Metal mouthpiece, you can follow me, or add my WeChat ID: wdwd348
Click to learn more about Yamaha metal mouthpiece
-
-
-
-
-
-
-
-
-
-