shared with me that he removed the iPhone battery without authorization, which caused the battery to burn and the phone was damaged. I am very sorry to hear it. Thanks to the dismantling experience of the past few years, I would like to share some tips for users who are going to dismantle and replace the iPhone battery by themselves.
recommends
1. It is highly recommended that users without disassembly experience do not dismantle the phone without authorization, especially if the iPhone is still under warranty.
2, the battery chooses the big-brand, regular original battery on the market, so I won’t introduce too much here.
3. Preparation tools: battery, 4-shaped screwdriver and 6-shaped screwdriver, suction cup, crowbar, hair dryer
operating tool
operation start
1, unscrew the two screws at the bottom end of the iPhone;
2, suck the position near the Home button with a suction cup The screen, then the index finger and middle finger are applied at the same time to lift the screen out of a small corner;
3, insert a spudger into the small corner of the screen, and slowly slide to the left and right sides to the top side of the screen;
4, gently lift Screen, this step requires great attention, the angle of the screen should not be 90 degrees to the body, otherwise the screen cable will be damaged! ! !
5. Turn off the power, unscrew the two screws of the battery interface, tilt out the shield, and pull out the power buckle; the two screws of the
battery
6, remove the screen (this step can be performed or not), remove the top 5 Turn up the shielding cover, buckle, and remove the screen; 5 screws
7 of the
screen. Use a hair dryer to heat the back cover of the fuselage to melt the battery glue and make it easy to remove the battery.
Many users start to get stuck at step 7. In many cases, the old battery cannot be removed smoothly because the battery glue is broken during the pulling out process. Pulling the battery is a technology, and the battery glue must be fully melted before pulling. Come out, this step can't be rushed!
8. After the battery is removed, buckle the screen cable to replace the new battery. needs to pay attention to the screws corresponding to each hole of the battery. Don't screw it wrong, because each screw is different in length and is easily damaged. Cell phone.
9. Select the spare battery, insert the battery buckle, and press and hold the power button to see if it can be turned on; if there is no problem, turn it off again, stick the battery glue, pay attention to the front and back of the battery glue, do not stick it backwards. To avoid the difficulty of replacing the battery next time; press the battery buckle tightly and install the shielding cover.
10. At this step, the basic operations are over. If you need to install waterproof glue , you can put a circle of waterproof glue on the inside of the fuselage. Then press the screen tightly and turn back the two screws at the bottom.
So far, the battery replacement operation is complete.
pay attention to
1, if you have no previous disassembly experience, it is recommended to empty the battery before disassembling;
2, pay attention to shut down before disassembling; any operation of
3, is: power off first to install and install at Be sure to pay attention to the power off! !
4. When removing the screen, pay attention to the angle between the screen cable and the fuselage, and be sure not to stretch the screen. This operation of is very easy to damage the screen cable, and the maintenance fee is not easy! !
Finally, I wish every little friend who hands-on can successfully disassemble the machine!
This article was originally created by Joy of Science and Technology, welcome to pay attention and bring you a long knowledge!
-
-
-
-
-
-
-
-
-
-